• Bull socket plug-in board with line genuine independent switch household power drag wiring board porous wireless 5 meters
  • Bull socket plug-in board with line genuine independent switch household power drag wiring board porous wireless 5 meters
  • Bull socket plug-in board with line genuine independent switch household power drag wiring board porous wireless 5 meters
Bull socket plug-in board with line genuine independent switch household power drag wiring board porous wireless 5 meters
  • Feedback

Question: How to wire the bull wiring socket?

Answer: Insert the wire core into the hole (type text on the module) Step 4. After inserting the wire, tighten the screw on the top of the module (do not use excessive force to cause the screw to slip...

Question: How to wiring diagram of bull socket panel

Answer: Expansion information Bull socket is male...

Question: There are three wires in a bull socket, which one should not be connected to?

Answer: Any electrical appliance must be grounded for protection, but there are currently no grounded busbar connectors in many aspects. Even if this yellow-green wire is connected from the electrical appliance, it is still not connected to an effective grounding busbar...

Question: Multipurpose socket gn-317 220v 10a bull 4 bit 3m one control one independent...

Answer: , Blister use, home and special office or special jack

Question: How to wire the bull terminal block?

Answer: 2. When connecting the lines, connect the red wire (fire wire) and the blue wire (neutral wire) to the terminals L and N respectively, and the yellow-green two-color wire to the socket terminal N, then...

Question: Switch socket panel open wire box 1 open with 5 holes and five holes power supply how to wire

Answer: The power switch is generally between 120 cm and 135 cm from the ground (generally the height of the switch is...

Question: Bull socket, three-hole power strip, why the hole on the top

Answer: Answer: The normal one is the lower left one is positive

Question: What is the difference between a bull power strip and a switch socket?

Answer: Answer: A DC, a shunt switch socket is applied to the original line, that is, the socket we often see on the wall. The extension board is generally applied with not many sockets or the line is not long enough

Question: The fuse of the bull socket is blown, how to remove the fuse

Answer: In fact, just buy a fuse and replace it.

Question: How to identify the authenticity of the bull patch panel

Answer: 3. Tear off the upper anti-counterfeiting film from the corner of the anti-counterfeiting label (upper left corner), put it on a flat white paper, and lightly paint the surface of the anti-counterfeiting film with a water pen or ink.

You May Also Like